One more with model space / paper space linetype confusion

[lpseifert]

I mucked around with the linetype of the red line (changed it to ISO Dashed) and got it to display the same in both viewports. Then changed it back to the TV linetype (Bylayer) and they displayed properly. Go figure... maybe it's something in the TV linetype definition.

[the-trooper]

I mucked around with the linetype of the red line (changed it to ISO Dashed) and got it to display the same in both viewports.

Viewports? They display the same in both viewports for me too. I want spacing of that line in viewports, and on paper space to be equal to model space. Now it's much "bigger", no matter what line type i try.

Can that be done, or did i mess up some other scale variable...

[lpseifert]

I don't know what to tell you... the red line displays the same in both viewports and paperspace here.

[the-trooper]

Damn... See that picture i attached above, definitely not the same...

[the-trooper]

I mucked around with the linetype of the red line (changed it to ISO Dashed) and got it to display the same in both viewports.

Could you please attach that dwg, i cant get dashed lines to display same in model space and paper space no matter what. I tried with blank new drawing, without custom linetypes, and againg, spacing of lines in paper space is much bigger then in modelspace.

[lpseifert]

I created a new layer 'test' using the Iso Dash linetype
Increased the length of the red line... like I mentioned before I think it's in the TV linetype definition - in the 100 scale viewport the line was too short to display properly.